Design Of Single Side Zipper Short Boots For All Day Gourd Heads

If the location of the gourd head extends to the mouth of the cylinder, it becomes an all summer gourd. The method of designing gourd and common gourd is the same. It is the length deformation of the gourd head, and the double conversion method is also used.

1. finished product drawing
As shown in Fig. 5-2-12, the front part of the shoe is made up of two components, and the front block has an all day hoist. There are zippers and zipper tongue components in the back of the gang. The outer structure is rear pressure, and the back pack is directly connected with the break line. When the rear part is close to the heel, the post press technology is often applied to match the heel line of the heel.

2. structure design drawing

As shown in Fig. 5-2-13, the height of the back tube is 120mm and the width is 125mm. First design the back frame and then design the front part.

Take the 0 'point as the center of the pick up, take the changeover in the lower part of the front Gang, take the 0 point as the picking center, and take the conversion switch on the head of the gourd. Also use the copy board to trace the outline of the gourd head. It is not difficult to see from the diagram that the length of the bottom edge of the gourd head is obviously lower than the original length, and the goal of the last step can be achieved by stretching the bottom edge of the upper beam.

Other designs are high waist shoes.