Technical Requirements For Cutting Of Woven Garments

Before drawing, it is necessary to draw out the layout chart according to the template. "Complete, reasonable and economical" is the basic principle of discharging.

stay

The main process requirements are as follows:

(1) clear the quantity when dragging material and avoid defects.

(2) for different batches of dyed or washed fabrics, they should be cut in batches to prevent chromatic aberration on the same garment.

Chromatic aberration should be used in a fabric with chromatic aberration.

(3) when discharging, pay attention to the straight thread of the fabric and whether the direction of the silk thread of the garment is in accordance with the technological requirements. It is not possible to reverse the discharge of the pile fabric (such as velvet, velvet, corduroy, etc.), otherwise it will affect.

The depth.

(4) for the fabric with stripes, we should pay attention to the alignment and positioning of the stripes in each layer, so as to ensure the continuity and symmetry of the stripes.

(5) cutting requires accurate knives and smooth lines.

The overlay should not be too thick.

The upper and lower layers are not biased.

(6) cut the knife edge according to the pattern mark.

(7) attention should be paid to the appearance of garments when using cone hole marking.

After counting, we should check the quantity and check the film.

Specifications are divided into heaps and bundled, with the ticket number, location, specifications, etc.